A leak you can see is the easy case. We find the ones you cannot — under slabs, inside walls, on the buried run from the meter.
Farewell Bend Park is a 22-acre park along the Deschutes River, in Bend's south side on the Deschutes.
Seasonal river level and irrigation-season groundwater both affect how a compromised lateral behaves on these blocks.
Bend Plumbing Pros works this part of Bend the same way we work the rest of it — same crew, same equipment, same-day availability on most calls, and a free estimate before anything starts.
Call (888) 616-9423Freeze-stressed pipe that split partially, weeping into a wall instead of bursting
The buried supply run between meter and house, invisible until the bill says otherwise
Galvanized supply in the older core, which thins inside and weeps at threaded joints
Pinhole failures in older copper, which repeat along the run rather than once
Hose bibs and irrigation connections leaking inside the wall after frost damage
Toilet flanges and supply valves soaking subfloor quietly for months
Leaks you cannot see still leave evidence. This is what to look for.
| Sign | What It Usually Means | What We Do |
|---|---|---|
| Water bill jumped with no change in use | An active leak, often on the buried supply run | Meter test, then locate before opening anything |
| Meter still moving with every fixture off | Confirmed supply-side leak | Isolate by section to narrow it down, then expose and repair |
| Warm or damp patch on a floor | A leak on a hot line under the slab | Locate acoustically or by pressure, then plan the least invasive access |
| Staining or soft drywall with no visible source | Slow weep inside a wall cavity, often freeze-stressed | Open the minimum area needed, repair and pressure-test |
| Repeat pinholes in the same copper run | The run is failing generally, not at one point | Repipe that section rather than patch it again |
| Musty smell in a crawlspace | Long-running slow leak wetting the ground below | Locate the source and check for damage that needs drying |
The repair is usually the simple half. Locating a leak that is inside a wall, under a slab, or buried in a yard without opening the whole building is where the actual skill sits.
The sequence we work through starts non-invasively: isolate sections of the system and watch the meter to establish supply side versus waste side, then narrow the location by pressure testing individual runs, then confirm the position before anything is opened. A leak found precisely means one small access point to patch afterwards.
A leak found by guesswork means several, and you pay for all of them twice — once to open and once to close.
If you suspect a leak but cannot see one, this narrows it down before you pay anyone. Turn off every fixture and appliance that uses water, then find the meter and note the reading or watch the low-flow indicator. Leave it an hour with nothing running.
If it has moved, you have an active leak on the pressurised side of the system, and the fact that you cannot see it means it is going somewhere that matters. Tell us the result when you call — it changes what we bring and saves diagnostic time you would otherwise be paying for.
A leak in a line running under a concrete slab announces itself in ways other leaks do not: a warm patch on the floor if it is on the hot side, an unexplained running sound with everything off, a section of flooring that stays damp, or simply a water bill that has climbed for no reason.
They matter more than an equivalent leak elsewhere because the water has nowhere obvious to go and can undermine the slab before it ever surfaces. The repair options are genuinely different too — breaking through to the pipe, or rerouting the run entirely and abandoning the section in the slab.
Which one makes sense depends on the pipe’s condition, its depth and what is on top of it, and that decision should be made after locating it rather than before.
This is a specifically Bend pattern and it is worth knowing about. Not every pipe that freezes bursts outright. Plenty of them split partially, and a partial split weeps rather than floods — a few ounces an hour into a wall cavity or crawlspace, quietly, for weeks.
By the time staining shows on drywall or a musty smell appears under the floor, the water has been working on framing and insulation for a while.
If a line froze last winter and you have noticed anything since that you cannot quite explain, that is worth a look before it becomes a structural conversation rather than a plumbing one.
One failure on an otherwise sound line is a repair, and we will treat it as one.
The pattern that changes the answer is repetition: two or three pinholes on the same copper run, or any weeping at threaded joints on aging galvanized, means the pipe is failing along its length rather than at one defect. Patching those individually is a subscription.
Galvanized supply in Bend’s older core is the clearest example — once it starts, section repairs cost more over a couple of years than repiping the run once and properly. You will get both numbers so the comparison is in front of you rather than implied.
The repair bill is usually the smaller number. A slow leak running unnoticed does three things simultaneously: it bills you for water you never used, it wets building materials that were never meant to stay wet, and on a supply line under a slab or in a yard it can undermine what it runs beneath.
None of that is an argument for panicking about a dripping tap — that genuinely can wait for normal hours. It is an argument for not leaving a meter that moves with everything off, because that one is running continuously whether or not you can see where it goes.
Non-invasive first: isolate, test, narrow, confirm — and only then open. Finding the leak precisely is what keeps the repair to one small access point instead of several exploratory ones you also have to pay to close.
Call (888) 616-9423General Bend-area ranges for budgeting — your exact price depends on access and on what we find. Call (888) 616-9423 for a free, specific estimate.
| Service | Typical Range |
|---|---|
| Leak locate and diagnosis | $175 – $450 |
| Accessible supply line repair | $250 – $700 |
| Fixture, valve or hose bib leak repair | $150 – $400 |
| In-wall or under-slab leak repair | $800 – $3,500 |
| Repipe of a failing section | $1,000 – $4,000 |
| Emergency / after-hours surcharge | +$75 – $200 |
Ranges shown are typical Bend-area market pricing for reference only, not a quote. Every job gets a free, upfront estimate before we start.
Yes. Farewell Bend Park sits in Bend's south side on the Deschutes, which is inside our standard Bend service area. Call (888) 616-9423 and we will confirm your address and give you a realistic arrival window.
Most Bend calls get same-day service, and anything actively flooding or backing up moves ahead of routine appointments. Tell us what it is actually doing when you call — that sets the priority and tells us what to load on the truck.
Shut off every fixture and appliance, then watch the water meter for an hour. If it moves, you have an active leak on the pressurised side. Other tells: a bill that climbed with no change in use, a warm or damp patch on a floor, staining on drywall with no visible source, or a musty smell in a crawlspace.
That is the whole point of locating properly. We isolate sections, pressure-test individual runs and confirm the position before opening anything. A leak found precisely means one small access point; a leak found by guesswork means several, and you pay to open and close each one.
A leak in a line running under the concrete slab. It matters more than an equivalent leak elsewhere because the water has nowhere obvious to go and can undermine the slab before it surfaces. Tells include a warm floor patch, running water you can hear with everything off, or an unexplained bill increase.
Yes, and this is a common Bend pattern. Not every frozen pipe ruptures outright — many split partially and weep a few ounces an hour into a wall or crawlspace for weeks. If something has seemed off since a freeze, it is worth looking before it becomes a framing problem.
One failure on a sound line is a repair. Repeated pinholes on the same copper run, or weeping at threaded joints in aging galvanized, means the pipe is failing along its length — and patching those one at a time costs more over two years than repiping once. You get both figures.
Not as an emergency. It wastes water and it is worth fixing, but it will keep until normal hours and it costs less then. A meter that moves with everything off is the one that should not wait.
Yes. On Bend’s larger west- and south-side lots that run can be long, and a leak on it is invisible from the surface until the meter or the bill gives it away. We locate it before excavating rather than trenching the whole run.
We will document what failed and why, with photos, which is what an adjuster asks for. What your policy covers is between you and your insurer, and we will not guess at it for you.
Same-day availability across Bend, and a free estimate before any work starts.
(888) 616-9423 Request a Free Estimate